Connect cables to the RJ45 connector

Step 1: Peel off the outer skin of the cable by about 20 to 30 mm. Precautions: Do not cut the cable when peeling the rubber.

Step 2: Cut off the exposed cross skeleton, and cut it all together, taking care not to hurt the cable.

Step 3: (1) Clamp into the isolation skeleton of the crystal head, the left and right are orange or brown wire pairs, and the upper and lower are blue or green wire pairs.

Step 3: (2) Clamp into the isolation skeleton of the crystal head, the left and right are orange or brown wire pairs, and the upper and lower are blue or green wire pairs.

Step 4: Press EIA/TIA/568A for each pair of wires (green white, green, orange white, blue, blue white, orange, brown white, brown), or press EIA/TIA/568B for each pair of wires (orange white, orange, green, green, brown white, brown), arrange the wire sequence, and insert the other isolation skeleton firmware in the crystal head

Step 5: Cut the excess cores along the sides of the isolated skeleton firmware

Step 6: Push into the crystal head and push to the end

Step 7: Press, press evenly

Step 8: Test, test light one by one. Congratulations. Jumper crimping is complete.